deezulsmoke
ArboristSite Operative
http://www.harborfreight.com/cpi/ctaf/displayitem.taf?Itemnumber=3
Is this a pretty good deal for a 36" alaskan sawmill ?? I am going into the milling business, this will give me a really good excuse to get my 660 mag LOL I dont have any experience with these mills, so I will probably have a lot of questions. One I have in mind is I was looking at this mill and I can see how after you get a flat surface on the log you could guide the sawmill down the length of the tree section to cut your boards. My question is how do you get the first cut on top of the log to be parallel with the center of the section ?? Are there guide rails, ect. than you can purchase for this ?? I dont even want to think about how much money I have burnt up in the fireplace on cherry,oak, and hickory. These look like they would be a lot of fun to mess around with.
Is this a pretty good deal for a 36" alaskan sawmill ?? I am going into the milling business, this will give me a really good excuse to get my 660 mag LOL I dont have any experience with these mills, so I will probably have a lot of questions. One I have in mind is I was looking at this mill and I can see how after you get a flat surface on the log you could guide the sawmill down the length of the tree section to cut your boards. My question is how do you get the first cut on top of the log to be parallel with the center of the section ?? Are there guide rails, ect. than you can purchase for this ?? I dont even want to think about how much money I have burnt up in the fireplace on cherry,oak, and hickory. These look like they would be a lot of fun to mess around with.