The made in north america Old Magnesium Swap Meet.

[paccity]

great info for when i get to the couple logmasters i have.

 

[67L36Driver]

Looking for a loop or length of 7/16" x .058" x 72 driver chain. I do have a very few presets on hand.

I have a length of 9/16" x .058" x 66 drivers. And, a couple presets for same.
Trade?

 

[redunshee]

Have two nos Homelite 330 oil pump diaphragms. Part # 94675. Prefer to trade for Poulan S25 DA oil pump diaphragms.

 

[295 tramp]

anybody have a top cover for a IEL Pioneer RA with the script and medallion for sale or trade?

 

[kz1000]

What did IEL stand for?

 

[ILikesEmGreen]

Industrial Engineering Limited?

Sent from my E6782 using Tapatalk

 

[rocketnorton]

my 4th ra had that top. consider myself lucky findin one. other 3 had cast in lettering. b4/after pics. the after pics is the top on another rebuilt ra that I quicky repainted @ same time.

 

[rocketnorton]

not just a queen...

 

[67L36Driver]

9/16" X 66dl length of NOS.

Also Remington Mall repair kits.


Edit: Snagged wrong picture. Replaced with correct one.

 

[heimannm]

Carl - If you still have that chain in April bring it along, I will make it worth your while.

Mark

 

[67L36Driver]

Will do. My OMG and SL5R both have good loops of 9/16 so I don't really need this.

 

[sweepleader]

subscribe
:{)

 

[jerrycmorrow]

Need clutch shoe, 6 -shoe configuration, for my Poulan 401. Same as for 360, 361, 400. Tried shoe from home lite C5 but too thick.
Got trade fodder

 

[67L36Driver]

FWIW: I did some sorting on the dining room table and found I have a lot of 7/16" .058" gauge repair links.
Also some 9/16" and 1/2".

 

[67L36Driver]

Pair of bar plates for a Poulan 3700??

We got stuff and long green.

 

[MnSam]

I am on the hunt for a coil and condenser for this AH81. What are my chances of finding some parts for this?

 

[heimannm]

Looks pretty clean Sam. Are the points and condenser missing or just not working? The points should be salvageable with a good cleaning, you can probably get by with some substitute condenser if need be. The points may burn a little with prolonged use with the wrong capacitance but I doubt you will be using that saw as your primary firewood cutter.

I have run mine, but not for a few years.



Mark

 

[MnSam]

The points are the only thing there unfortunately. I don't even know what the missing parts look like.

 

[heimannm]

Carl - if you are still looking for 7/16" chain I have a roll at home.

I am in need of a fuel cap for my Solo 611 Twin, if anyone has one or knows which others will interchange I would most appreciate it.



Mark

 

[sweepleader]

Nice saw holding fixture, here is a pic of the one I have: