394xp

I'm a bit torn as to sell or not to sell my 394xp. It's in good condition, all oem parts and runs good. I have someone willing to buy it at 900$ CAD. It has the full wrap Here are some pics: I put it up for sale because I am in need of the money and I don't use it that much (maybe a...

Looking for a good 80cc or over saw, doesn't need to be running or beautiful either. I don't mind a project if the bottom end is good. Prefer husky and I don't care how old it is. Might be able to trade also depending on what it is. Thanks!

Just putting this out there to see if anyone would be interested and will post pics if there is. 20 for piston, 35 for carb, 15 each for tanks. Cranks sold

Looking for a decent Husqvarna 394 starter/recoil cover. In working order preferred. Rope condition not crucial.

Long story short my good buddy whos a saw nut like most of us has been having lots of trouble with his 880. He falls and mills large timber so he runs big cube saws often and has a lot of money wrapped up in 880 bars. I recently built an Olympyk 999 which just so happens to take large mount...

My 394xp was getting impossible to restart once warm so I knew the compression was getting low. Had it checked and sure enough, it was down to 100psi. In looking at the options I decided on the big bore kit from Little Red Barn...

Hello all, I am at a complete loss- my Husqvarna 394 chainsaw will start but immediately dies. It is a 1998 model. I have already tried the following: New Gas line New Fuel filter New Fuel tank vent New tank vent filter New Gas cap Put carb kit in it Cleaned the carb Air filter is...

Up forsale is a 394xp with new meteor piston, carb kit, am muffler, ports have just been cleaned up. Gasket, heat shield, muffler and cylinder all been matched. Base cut so squish is around .024". Muffler has had three ports drilled in front, spark screen fitted for those three holes. THIS SAW...

I purchased this saw from a member here (04titanse) a few years ago and it's been great to me. This saw didn't get much use but boy was it fun! Aside from milling 3 logs (two of them were under 12" diameter and one was about 24"), it was used under normal conditions if you don't count the bee...

As title says, looking to rid my shop of these extra parts. Pm with inquiries

Hi Everyone- I'm looking to buy two things- a decent full-wrap handle for a Husky 394/395, and a copy of Jerry Beranek's book- "The Fundamentals of General Tree Work". I used to have several copies but gave them all away as gifts. Thanks much, JJ.