435

Wesspur
Rugged made
Arborist Forum

Help Support Arborist Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. S

    Husqvarna 435 Bogs and Dies

    Hello Everyone, I have a strange issue with a 435. It will start and run fine, after some time idling it will bog and die as soon as you hit the throttle. It will fire right back up after and run again, revs fine, then again, after some time idling it will bog and die when you go to rev it...
    • skirby
    • Thread
    • 435 carb chainsaw coil husky husqvarna husqvarna 435
    • Replies: 15
    • Forum: Chainsaw
  2. Gomofast

    Husky 435/440 - RTV/sealant or no?

    I'm replacing the crank seals on a 435 and using new rubber cylinder base gaskets as well. Should I use any RTV/sealant/grease or just put the gaskets and seals in as they are?
    • Gomofast
    • Thread
    • 435 440 gaskets seals
    • Replies: 11
    • Forum: Chainsaw
  3. Pakai Boti

    Husqvarna 435 issue

    Hi, i have a husqvarna 435, but when i push the primer bulb 6 times,gas comes out of the tank vent.It starts very hard,runs good but stalls.I replaced the fuel lines and the filter too
    • Pakai Boti
    • Thread
    • 435 chainsaw fuel husqvarna issue tank
    • Replies: 0
    • Forum: Chainsaw
  4. thefarmboy21

    Husqvarna 435 X Torq problems, need help. Starter, fuel leak, not getting full throttle, etc

    The other day a guy from work called me up, because he was having problems with his 435 Husky. He said it sat for several months (apparently somewhere moist cause the bar and chain had fresh rust) and got it out to do some work around the farm. According to him he got it fired up and then it...
Back
Top