545

have a 545 auto tune that i got from a coworker and I couldn't seem to figure it out. I changed the top end since it was toasted, after the topend it started and ran well for all of about 5 mins then saw would start run for a coupler of seconds and cut out. so I took it to the shop in town and...

I'm looking for a used 550/545 mk1 cyilinder, the one that i have now may not be salvageable. Lots of transfer and scoring. Ideal would be a cheap OEM jug with some polishing to do to it also.

FS Jonsered 2253 with the MMWS treatment. The saw has less than 1 hr of runtime according to the dealer who updated the carb software in Sping 2019.if you’re not aware of this model it’s identical to the 550xp MK1 but just in red. $750 Shipped Paypal F&F to your door if you live in EST, CST, or...

Husqvarna 545 fully rebuilt from the crank up with all NEW OEM parts. Cylinder, piston, ring, bearings, seals, case gaskets, lines, filters, clutch drum, oil worm gear, .325/7T sprocket, spark plug, etc. Pressure and vac tested 100% using OEM Husqvarna block-off plates. I have video of it...

Husqvarna 545/550xp cylinder in excellent condition no transfer, scoring, or other damage. It still has the cross hatching in the cylinder from the factory. P/N 577 76 47-06 Also fits Jonsered CS2252/2253 $50 Shipped

Looking to replace a vintage 55 that was accidentally destroyed. (Bushhog shredded) Trying to locate a new or used Husqvarna 545, but have not been able to find an Atlanta dealer in stock. Have found 550XP's, all at $599 Would also be interested in a used 550XP, or 346. Trying to stay in that...

Hello everyone, I just purchased a great looking husqvarna 545 autotune for around $150. The problem with it is the cylinder and piston are scored, The reason it scored is because the side transfer port leaked and it ran lean. My question is are there any aftermarket cylinders/piston kits out...