carb rebuild

I was given an old Husky L65, and told it was "a bit hard to keep running". It had great compression and started up easy after I cleaned it out, but it was indeed hard to set a low idle that wouldn't promptly stall. I did my very first carb kit on it, and now it idles way too fast, even with...

Hey all! I'm trying to find a repair kit for this Walbro carb from a Dolmar PS-420C. Should I be looking for a kit for a "WTE 142 6B", which I can't really find; or is this the same as a WT-142 and the easy to find kits for that are the correct ones? Are after market kits good enough or should...

Hi all. I'm so glad I've found this forum. Been fighting a problem with my saw for months and have been too stubborn to pay a shop to fix it when I know the answer's out there and I enjoy hands-on work. Here's the situation. Have an Echo CS-400 saw that I've used only a couple of hours a...

I've been working on an older Stihl 015L top handle saw. It started developing a ping sounds and would stall out after running 30'sh seconds... turned out to be a worn crank bearing (possibly run too lean or vacuum issue?) that resulted in the crank slightly shifting, making the rod rub against...

hi guys, I'm wondering if anyone knows whether an 046 carb will fit an 044? And if there was a non compensating version of the 046 carb made? I'm building a ported fairly highly modded 044 and I'm worried about running lean, it'll be setup on the air filter side with a custom bell mouth and...

I have a small, one cylinder, two stroke engine on a Mantis tiller. The air filter gets fuel soaked after 30 minutes of use. It runs normally with a new air filter or when the air filter is removed. The tiller starts to bog down as the air filters starts to gat fuel soaked. It has fuel...