crankshaft

Hi! Just looking to see if anyone can double check my brain capacity in reading IPLs... I'm looking to order a crankshaft for a 362C with serial # 189xxxxxx. Which one of these two should I order (#37 is just #38 plus a screw or something). I am just hesitant because it seems like I'm mostly...

Note: This crankshaft comes with 2 key slots and is compatible for the DOLMAR 143 with contact ignition only. Limited stocks left, PM me with other DOLMAR parts as well to make it worth the expensive freight from Singapore to USA. 031120201 CRANKSHAFT CPL -oldpartsinasia Joe

So during COVID found a guy in a farm town selling a MS440 for $200, it was run hard and put away wet, but it ran, so I bought it. Then I got the great idea to "fix" what wasn't broken. Here is my advice to anyone who runs into any similar issues that I had along with a MASSIVE thank you to the...

Hi Folks, I recently bought an used engine off ebay for building another MS461. Piston and cylinder were heavily scored, but their replacement was intended anyway (had an OEM kit waiting). Upon disassembly, I discovered that the crankshaft is shot too (the captive bearing is missing chunks)...

I have a ms660 huztl clone that i built. Ran amazingly for all of about 4 hours and then started having some strong engine vibration. 2 or 3 minutes later (i really wanted to finish the last few cuts) it seized up. Disassembled the top end and found that the rod->crankshaft bearing is...

I got every part I need to build the 390 engine. Then I can just swap it on to the 290 chassis. This is one way to completely test Hyways products. Would you guys put a little Motoseal around the oil seals?

What is allowable horizontal end play for a STIHL 200T? By that I mean one end of the shaft to the other in and out of the case, not typical side to side. I picked up a couple of these in a huge lot of equip, both have probably a 32nd or horizontal end play. I'm not very familiar with these...

I've got a 661 I'm working on. P&C got destroyed, and I may have found the reason why. I took the P&C off, and the crankshaft is rough to turn by hand and nearly impossible with the starter. It's good for about 2/3 of the rotation but 1/3 is rough and hard hard to turn through. Flywheel isn't...

i have some extra parts left from when I rebuild my stihl 041 super... the flywheel is the points style, I believe the part number is 1110 400 1205. a basically new carburetor and the crankshaft (I just replaced it because I could buy the piston, bearings and shaft as a unit) there is one...

Part # is 1113 030 0400 brand new in box! would like $35.00 obo