engine

Hi Guys, This is my first post here. I am interested in small engines and in particular Rotary Chainsaws like Sachs Dolmar KMS-4. I am hoping a knowledgeable person here can help me with a technical question... How does the internal parts of a Rotary Chainsaw get lubricated? Such as the...

Hey everyone, I have a 361 that I bought used about 5 years ago. I use it 2-3 times a year without issue. This year I started it up for the first time, first cut went fine/ran perfect...second went a little slow. Third bogged down and stopped. I started it again...died after 15 seconds and...

I have been looking at Honda gx engines for a unique new DIY mobile bandsaw mill build. Non-trailer so I will design it to be moveable in two or three wheeled/lifted pieces by one person. I've designed the basic system; it's just two rails that secure at each end of the log, at each corner...

Hi guys, my fs450 seized recently and with Stihl asking for $550 just in parts for a new cylinder and piston I thought I'd replace them myself. Now before I ordered them I thought I'd check it wasn't also needing a crank shaft, and sure enough it is. The con rod wobbles like it's never seen a...

Looking to start a rebuild on an MS290. I bought a Husky for the interim. I have a small nylon rope, but it's long and small diameter. I don't normally have any cheap nylon rope laying around (lest someone use it). I was going to buy a couple feet while I'm in town. What size diameter works...

Hi.I have a husqvarna 136,but it's kinda weak.I am asking that is it even possible to put a Stihl engine in it?