holzfforma

Hello All, Long time reader, first time poster. I wanted to warn everyone of the underhanded tactics Farmertec utilizes. I like most other people, could not afford a big saw for the little work i was planning on using, and could not even afford a used big saw that i could find. So i was...

Hi everyone, looking for some advice. My brand new cs will only start under full throttle, can't even get nice sputtering with choke on. It will also run at full speed when the gas tank gets fully depleted. I tuned it up what I thought was nice but this didn't solve my issues. From looking it...

I smoked my cylinder on my 660 clone while milling by having the high adjustment too lean. Now I am holding a new 36$ knock off cylinder in my hand and have just ordered a degree wheel to check timing. By just measunring with the calipers I can tell that this cylinder is way off compared to the...

I noticed an advertisement for a Holzfforma G666 and a G372 chainsaws on the Huztl website. My guess is that the G666 & G372 might be assembled saws similar to the companies 070 offering. What do you make of this? I assume the “G372” is a husky 372 copy? What about the “G666”?

I noticed they had rolled out some larger bars over the 14" bar and chain loop they introduced the brand with. I put 3 - 16" loops and a 16" bar in the cart and shipped they were a few cents less than $40 total. here is a 16" loop...

I got this a few days ago and today did an unboxing video, what's in the box. The camera will give you a really good look at each part. Right now you can save a bunch of money on shipping as it is included. I have a MS660 that I built from a Huztl kit but I want a 070 to be it's permanent...