hybrid

I have an old 440 that I just made a 440/460 hybrid. I put a brand new carb on it when I did the swap because when it was just a 440 I couldn't ever get the carb adjusted correctly, or so I thought. The 440 piston was also absolutely shot so I never really thought about the issue being anything...

Alright here goes, As the title says I performed my 2nd 064 to 066 big bore conversion, not sure if that's relevant to this issue though.. After the swap I pressure/vac tested, found a leaking Flywheel side crank seal, replaced that. Then found a leak at the clutch side bearing seat in the...

Hey guys how goes it? Im looking for a 660 oem cylinder for my 064. Plan is to end up with a ported 064 hybrid. Just need a cylinder to start with. Love the saw just always want a little more power to pull a 404 chain. First post so please forgive any faux pas.

Hello, I am curious as to how to create a hybrid maple tree and how long it typically takes to cultivate a hybrid. I believe this is a decades long pursuit, but I'm hoping it's not always. The two cultivars I have in mind are the laceleaf japanese maple and the paperbark maple. The desired...

All tags missing on this saw. after some research I believe it is a C-72. It runs well but w best loaded carb tune seems a bit weak. It may have a case seal issue. I figure if I am going to take the time to pull it all down I might as well go stupid on it for the fun. Here we go. What is the...

Hey all, I'm in the market for a Stihl 044 or ms440. Dead or alive, it doesn't matter. A "parts saw" would be perfect. I don't really care what condition the saw is in. All I really need is a saw with a good case and a good 12mm crank. I'm hoping to find something in the southern Ontario...