issue

only about 50% of the time. The rpms will drop and the motor sounds like it's trying to sort a bad idle. This can also be caused if I take an ambitious bite or sweep on an angle in to the stump. High idle doesn't recover until I've either disengaged the head and rolled the dice again on...

My 394xp was getting impossible to restart once warm so I knew the compression was getting low. Had it checked and sure enough, it was down to 100psi. In looking at the options I decided on the big bore kit from Little Red Barn...

Hi, i have a husqvarna 435, but when i push the primer bulb 6 times,gas comes out of the tank vent.It starts very hard,runs good but stalls.I replaced the fuel lines and the filter too

Hi guys, I am having an issue with a dolmar 5105 that I purchased from a gentleman on this site a couple years ago. Easy start, fully adjustable carb, 5100s muffler to keep heat down, a tach to check rpms. About 25 hours on it since I got it. Not much use in it before I got it. I have run...

Hello, I do woodturning and a couple of days ago I've bought a new 465 Rancher to cut logs and have them ready for the lathe. When the chainsaw arrived, I've followed the instructions step by step and it started and ran smoothly (just for 10 seconds, then I've switched it off). Starting from...

Hi everyone this is my first post. I have a disgruntled homeowner from the neighboring property of where I just took down a large maple cornered in by powerlines. So i get the tree down and cut the stump, and my subcontracted stump grinder guy comes in and grinds the stump in the morning. I...

Okay so I watched a guy flush cut a stump today, now the way I was shown was, you clear out as low as you can go without hitting dirt, rocks, chain link fence, and other stuff, get on your knees put the saw sideways, eyeball the bar levelness and cut 90%, insert wedge or bark and Finnish the...