port and polish

Arborist Forum

Help Support Arborist Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. U

    MS260 HOT SAW

    Up and running, I need to tach it and fine tune in the cut but it works and is a work saw more or less than a race saw. Haven't decided how I'm wanting to operate the choke lever. I think it rips! Was also my first time customizing a saw🤓
  2. S

    Port and Polish 101

    Hi all! I’ve been wanting to attemp my first port and polish for a while now, but I can never seem to find good information for newbies. With all the videos I’ve watched and threads I’ve read, I’ve gained a basic understanding of the goals. But still a lot of it seems to go way over my head...
  3. Ashland23

    Ms361 porting

    Hey everyone! First time chiming in here. I love the forums by the way! So I’m planning on doing a port job on my ms361. Just wondering if anyone has some good numbers to start with or any ideas to go off? Not planning on anything super crazy. Maybe just a good woods port or just a tad more than...
  4. Woody Longbranch

    394 needs rebuilding in northeast

    I bought a stock Husqvarna 394 that ran really good till the tiny screw that holds the choke plate on the shaft got sucked into the case. I took it apart and found the tiny screw lodged between the case and the crankshaft. Put it together with a new pre-loctited tiny screw in the choke baffle...
Back
Top