stihl 044 rebuild

Arborist Forum

Help Support Arborist Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. C

    Stihl 044 Slant fin questions..

    I purchased this stihl 044 for 300 dollars in hopes of a 10mm slant fin.. it was seized up, cylinder pitched at an angle when looking through exhaust port.. I managed to get the jug off and figured it was seized in the bottom end. After a lot of research I think I have a 10mm in hand. Figured i...
  2. WoodChip333

    Stihl 044 10mm c&p pics and numbers need advice!!!

    Hey all, I am a newb on here, but wait before you slam me with the filter and muff mod stuff. I bought a early 10mm stihl 044, its a 120's serial number. Compression is 125psi so I pulled it apart to have a look. Lots of nasty piston skirt scoring and scratches. Base gasket measures 0.040" which...
  3. Callum

    Stihl 044 10mm info

    hey. I am new to the forum. I just purchased a 044 10mm. The seller claimed it has bad bearings. Is there a way of checking this without removing them and splitting the case. Also. Is the crankcase gasket the same for the 10mm and 12 mm version.
  4. super029D

    Stihl 044 Clutch side oil seal

    Guys just picked up a 044 10mm pin chainsaw off the CL. Starting to rebuild with OEM piston, ran into a issue with the clutch side oil seal. When I pressed it into position I noticed that the lips of the seal don't fit around the shaft like other Stihls ive seen, 025, 039, ect... Do I need to...
Back
Top