I have an HT 131 that got a bent shaft just below the clutch. After repairing the shaft I rebuilt the C1Q-S98C carburetor since it hadn't been used in quite a while and the primer bulb had rotted and cracked. New gaskets, primer bulb and check valve plate, and fresh fuel. I set the screws back...
Hello, I have two chainsaws that I suspect are running rich due to poor air flow. One is an 038 magnum and the other is a Chinese ms381 clone. They both have aftermarket air filters that seem to function well but in order to get the saws to run properly the H screw has to be turned to about 3/4...