wont start

This is the only sound I can get out of my saw.. the carb is new and my friend changed the coil,but it acts like it's not getting a spark. It's getting a spark I looked.. any suggestions? It's only a little over a year and a half old.

So I'm a newbie. I've done a little bit of clearing for work, so I'm comfortable with saws. Planning on getting some vacant land soon and figured I'd need a saw to clear stuff on there/fire wood. I have this condition where instead of buying a new, working machine, I'll buy an cheap broken...

Bought a 445 as a parts saw but decided to repair and run it. Having zero luck getting this thing running. New Carb(dry tuned 1.5 H/L), new lines, air/fuel filter, new plug with good spark, rubber necks not torn nor have holes, piston is good and compressing at 170. Sure I’m missing something...

I have spark, I have fuel. I have 130lbs compression with just 3 pulls. I have gapped and I regapped and regapped the coil/flywheel... Mind you, I have good blue spark when I put the plug in the boot and ground it on the cylinder head. Put the plug back in and try to start it I get nothing. I...

After pressure washing then blowing mostof the water off with an air blower, grinder won't turnover without the gas and hydraulic access lid fully in open position. Could anyone explain why this would happen or have ever had this happen to them?

Hi. I have a mighty merc wood splitter with a 5hp tecumseh enduro engine that won't start. Spark is good. Cleaned carb would fire but not run, won't run when fuel is put in spark plug hole, would fire off either once or twice real quick. Plug seemed dry. Replaced carb and same results. Carb does...

Hi everyone. For a while now I’ve been having trouble with my Partner 370 chainsaw. It cold starts and runs fine but after I’ve cut for a while - 3 or 4 mins, then stop cutting it switches itself off and will refuse to start again no matter how many times i try. After leaving I for a long time...

I recently was given an old stihl 025 from a friend. When I got it, it had a piston that was in bad shape, and the crank bearings and seals were shot. After replacing the piston, seals, bearings, cylinder, impulse line, and gas line, the saw was able to start, but not idle. I thought maybe it...

I have a ms660 kit that has been detailed here in forum and its ran great, trouble is i can not get it to crank and was wondering if you would be willing to help. here are the things i have done. building the kit was an education i would have never gotten this far without the hands on experience...