Want to Trade 44mm piston and ring for husky

[brian.b]

hey guys i have a 44mm piston ring wrist pin bearing and circlips from hutzl ,,does anyone need this.

 

[Milkman31]

Wish it was 45mm

 

[80sDweeb]

I've got a 350 non-EPA with a toasted piston, I believe that's a 44mm, correct? So I think it would work for me. It's an open port saw, if that makes a difference.

Scott in Penfield NY

 

[brian.b]

80s dweeb,,,im not sure i ordered this for a 350 but mine is made after 03 and i read that saws before 03 were 44mm and anything after was a 45mm,,i dont know about the open port.

 

[80sDweeb]

Well I've got 3 of these 350s, and one has the 44mm flat top piston, the other two have 45mm dished pistons. The 44mm piston is bad, but I hope to save the cylinder (like Mastermind shows in his Youtube videos) so I'm pretty sure I could use that. What would you want for it?

Scott in Penfield NY

 

[brian.b]

i really dont want anything for it i just put for trade so i could post here,,, do you have any parts for an 029 or 036,,,send me your address and i will send the parts to you.

 

[brian.b]

i will send them to you for free ...but i am looking for an 029 handle,,,and air filter cover...but just give me your address and ill send it out.