A crummy veiw

Arborist Forum

Help Support Arborist Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
461 and an 046, but that was in my hand when I took the pic, back of the truck was full of brush, no place for saws to ride but the front seat... I did crack a window you know so they could breath, and bark at people while I was at the gas station...
 
461 and an 046, but that was in my hand when I took the pic, back of the truck was full of brush, no place for saws to ride but the front seat... I did crack a window you know so they could breath, and bark at people while I was at the gas station...

Do you stop and let them out every few hours? Hope they don't drool too much or put nose prints on the window.

I'm not seeing coffee cup rings on the dash so you must use coasters. Some doilies might work as well.
 
461 and an 046, but that was in my hand when I took the pic, back of the truck was full of brush, no place for saws to ride but the front seat... I did crack a window you know so they could breath, and bark at people while I was at the gas station...

Does nobody see how that looks like just one long bodied powerhead?
 
Do you stop and let them out every few hours? Hope they don't drool too much or put nose prints on the window.

I'm not seeing coffee cup rings on the dash so you must use coasters. Some doilies might work as well.

It was a short drive but they got to go walkies when we got there.

The coffee is sort of everywhere, so rings look more like texture...

Hammer the picture is expanded a bit so it isn't so tiny, could explain the confusion...
 
A lot of the cutters around here take the back seats out of the 4 door pu's ,the backseat area looks a lot like that
 
That 'aint not too bad at all. Here's my old truck from last year, just after I cleaned it up. Saws ride in the back. 'course we drive on the other side of the road, with the driver sitting in the proper position.

attachment.php
 
That 'aint not too bad at all. Here's my old truck from last year, just after I cleaned it up. Saws ride in the back. 'course we drive on the other side of the road, with the driver sitting in the proper position.

attachment.php

That looks more normal. I've accepted rides back up the hill or down in the rigging crew crummie and they had to keep it a bit less cluttered so everybody could fit in, but the seats had the springs coming through and there was the smell, which was a mix of chew, diesel and persperation.

My FS truck had a bare of paint spot where I climbed in with calks on. The pedals get messed up too.
 
I have been very very careful this past week ..... I have had a rent-a-wreck .. so I put down some carpet on the back floor (its a 4 door) to put my saws and junk on and a piece in the bed ( had to change cable on the winch and carry fuel cans) . The rent-a-wreck is a 2013 chevy silverado lol
 

Latest posts

Back
Top