A041 mount bars

[jellyroll]

Looking for any and all advice on the best guide bar in this mount ( goes on my Echo CS-306 ) i am trying to avoid the single rivet sprocket nose as i have blown out a few even though i have kept them greased regular and i don't run the chains tight.

 

[scottr]

What bar length do you want ?

 

[jellyroll]

What bar length do you want ?

14-16 in .050 gauge.

 

[hotshot]

Not a sponsor, but these are good bars & I can’t seem to tear them up, lol.

https://www.ebay.com/itm/3825194276...uHEl2Ppyawo0Veeq0QWmcfAJk=|tkp:Bk9SR5Kz1LK9YA

 

[jellyroll]

thank you all for your help i appreciate it.

 

[Lightning Performance]

Not a sponsor, but these are good bars & I can’t seem to tear them up, lol.

https://www.ebay.com/itm/3825194276...uHEl2Ppyawo0Veeq0QWmcfAJk=|tkp:Bk9SR5Kz1LK9YA

My only 325 050 is a 66dl Husky small mount.

Do you think this will fit with some filing in the slot?



My OE bar on the 325 pitch Husky might be able to run regular LP or Picco like the rest of the bunch with a spur change, now due for replacement or a pro rim kit. Finding the correct LP rims could lead to using the 026/260 mini rim. I'm not sure if it's worth trying to make the swap. 325 NK is easy to get in full chisel and 325 spurs. LP can be a fun challenge like finding the large eight pin that will run Picco or LP. Still looking for a ten pin LP rim in 22mm seven spline large. Should be just under two inches across.

Edit 1:04pm
435 power head

 

[Lightning Performance]

thank you all for your help i appreciate it.

We are just hunting parts like anyone else.