adjusting carb?

[chevyforlife21]

on a husqvarna 125b? (yes i know a leaf blower) but i figure you guys will know. what screw is high and what is low? it has two black splined screws, it doesnt like to run when given throttle.

 

[smilin possum]

Welcome aboard man. Not real sharp on those but most of the time the low screw is the one nearest the engine and the other is the high.
Joe

 

[stihlman95]

when your looking at the carb screws, your low is to the left and high to the right

 

[chevyforlife21]

hey hows it goin not a new member haha but ive never adjusted the low and highs before either on anything,

 

[bobt]

The low adjustment is always nearer to the cylinder than the Hi adjustment screw. That is because the low speed is in front of the throttle plate and gives the fuel at idle, and then when the throttle plate is opened the hi speed begins to add fuel to the mix. Of course when the throttle plate is at wide open position, both the Hi and Lo give maximum fuel to the engine, and it runs at maximum RPM.

 

[chevyforlife21]

thanks guys, i will adjust it when i get the tool maybe tomarow, also does anyone know if the poulan carb tool works for huskys too?

 

[fidiro]

thanks guys, i will adjust it when i get the tool maybe tomarow, also does anyone know if the poulan carb tool works for huskys too?

Isn't it just a regular small little flat headed screwdriver to adjust H/L?

 

[chevyforlife21]

nope splined screws

 

[fidiro]

nope splined screws

Gotcha.

 

[Tedster2]

hey hows it goin not a new member haha but ive never adjusted the low and highs before either on anything,

For those about to rock,

 

[Tedster2]

For those about to rock,

Remember to cut the right one first, then use that piece to protect the fuel pipe from the dremel.

 

[camel2019]

I’d just grab a kit of the screw drivers for the $16 Canadian I just spent they have already been a life saver.

 

[Okie]

You can get the 12 pcs carburetor adjustment tool carb adjust kit for 2-cycle small engines.
I've found that I need these because I've ordered replacement carbs and the OEM won't fit the replacement.