Menu
Forums
New posts
Search forums
Terms and Rules
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Terms and Rules
Menu
Log in
Register
Install the app
Install
Forums
Equipment Forums
Hot Saws
Chain Sharpening
Are FOP really progressive depth raker generators?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Arborist Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Ranchers-son" data-source="post: 5950466" data-attributes="member: 145233"><p>BobL I have a problem/question I lowered my RA to 6* my TPFA is 25* My chain no longer makes a wide enough cut and and drags so much it overheats the chain in two cuts 18" burr oak Stalled the saw to. Thought it was cutting too aggressive until I tried to pull out and it stalled in open cut. I was cutting cookies so their were no external forces on the log. What could cause this? I've learned a lot about sharpening from your post but the more I learn the less I seem to know!</p></blockquote><p></p>
[QUOTE="Ranchers-son, post: 5950466, member: 145233"] BobL I have a problem/question I lowered my RA to 6* my TPFA is 25* My chain no longer makes a wide enough cut and and drags so much it overheats the chain in two cuts 18" burr oak Stalled the saw to. Thought it was cutting too aggressive until I tried to pull out and it stalled in open cut. I was cutting cookies so their were no external forces on the log. What could cause this? I've learned a lot about sharpening from your post but the more I learn the less I seem to know! [/QUOTE]
Insert quotes…
Verification
Post reply
Top