Sold Cannon/Woodsman Pro Double Ended Milling Bars: UPDATE and PRICE DROP!

[Bostonstrongboy1965]

I have 3 Woodsman Pro Double ended milling bars (Made by Cannon in the 90's for Baileys). They are all the same model #:

CDE--G1-50-63

CDE= Cannon Double Ended
G1= 14mm Bar slot
50= 50 inch length overall (effective cutting width is 38")
63= .063 gauge
All three bars have had use, but it appears to have been minimal to moderate at worst based on amount of finish left on them. There was some mild surface rust at a couple of the mount ends, and one has very slight wear on one rail side, but grooves look perfect and straight.
I am asking 225.00 each or 600.00 for all 3. I will ship in a rigid mailing tube, so that will factor into shipping cost. Paypal F and F please.

 

[Bostonstrongboy1965]

Bump! Accepting offers!

 

[Bostonstrongboy1965]

One sold.....two left. First buyer got the pick of the litter. Asking 185.00 each for the remaining two.

 

[Bostonstrongboy1965]

Bump.....
Only one left. The remaining one has a little bit of wear on the rails. Price reduced to $150 plus shipping.

 

[Bostonstrongboy1965]

Thought I had this sold with the bump, but still available.

 

[Bostonstrongboy1965]

Oops, spoke too soon....Sold pending funds!

 

[TRTermite]

Oops, spoke too soon....Sold pending funds!

Still available? you never tagged it "SOLD"

 

[Bostonstrongboy1965]

Sold

 

[Bostonstrongboy1965]

Sold

I am not able to mark as Sold. Thread tools are not active on this post.

 

[TRTermite]

I am not able to mark as Sold. Thread tools are not active on this post.

Was hoping but Thanks for the reply.