Hunt4lumber
ArboristSite Operative
I've been running my central boiler 1450 e classic for 4 years now. This year I changed out to new fluid and added Molly armor. Upon electrical startup of system this past weekend the temperature high limit 1 is flashing on my screen and alternating between 2.51 which I believe is the burn chamber temperature. I just put a new thermocouple in 2 days ago so I know it's not that. The furnace is cold because it won't enable the blower fan to run until I can get rid of the fault messages on it. I did run a diagnostic test that the controller has built into it and verified the three solenoids open and close and the fan blower motor turns on and off. The temperature sensor reads 11 ohms with cold water. And my dealing with just a bad, lightning strike possibly controller screen? Thanks Matt
