Menu
Forums
New posts
Search forums
Terms and Rules
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Terms and Rules
Menu
Log in
Register
Install the app
Install
Forums
Tree Care Forums
Wood Carving & Turning
Chain adjustment for 12” dime tip 1/4 pitch
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Arborist Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Franny K" data-source="post: 7910695" data-attributes="member: 97597"><p>Oregon 25ap is rated for 38cc,. 13rm is a bit more robust. I would think on a small sized nose you could get a lot of heat. Probably as tight as possible without too much heat. Try starting with one or two scrench screwdriver thicknesses sag off the bottom, depends on length as well. Just guessing.</p></blockquote><p></p>
[QUOTE="Franny K, post: 7910695, member: 97597"] Oregon 25ap is rated for 38cc,. 13rm is a bit more robust. I would think on a small sized nose you could get a lot of heat. Probably as tight as possible without too much heat. Try starting with one or two scrench screwdriver thicknesses sag off the bottom, depends on length as well. Just guessing. [/QUOTE]
Insert quotes…
Verification
Post reply
Top