Chainsaw dies under load or full throttle.

[AaronB]

I was milling this last week and all of the sudden the saw would die when at full throttle or die if it would have any type of load put on it at half throttle. Basically it would start and idle just fine, and even sounded good at half throttle but when I would push to mill it would die, and if I tried to go to full throttle it would die. After it died I never had a problem re-starting it.

At first I thought it might be the fuel, but my other saw (same brand) ran just fine with the same fuel, then I thought it might be the fuel filter, cleaned it and even changed it.

Also, this happened Wednesday morning, then ran fine after lunch for a while, I didn't mill Thursday, when I went to mill Friday morning the saw ran just fine for a while, until late afternoon, but then it started dieing again so I stopped, started the saw Saturday morning just to see if it would work (not milling) and it worked fine at full throttle. Its almost like something quits working when it gets hot.

What might cause this that I am over looking?
I am pretty new to saws so it might be something simple, but thought I would ask and see if there are other things to change/try/clean.
Thanks

*********Answers to other questions I got from anther thread.*********
Saw: Stihl 660, 3 yrs old
Wood: White Oak, 22" diameter
Running before: I used it the weekend before and did not have any issues, ran it through three 8' logs and everything ran fine.
Work done: none

My FIL and I finally took out and cleaned the spark plug (don't have a new one) and it ran fine after that, but it had been sitting overnight so it was cold, so it probably would of ran fine had we not cleaned it, but I didn't get to mill with the cleaned spark plug.

 

[fearofpavement]

Could be a coil related issue but sounds like fuel starvation to me. Check the fuel hoses.

 

[R/C Pilot]

Ckeck the fuel line inside the tank for being to soft and collapsing.

 

[chadihman]

Tank vent? Loosen the fuel cap when it runs crapy. That will tell you if the tank vent is your problem.

 

[autis]

sounds like fuel lines to me

 

[Fish]

Keep doing what you are doing, and you will be starting rebuilding threads, it may be too late now.

Take off the muffler cover and show us a pic of the piston for starts.

 

[CTYank]

You can insert an ignition tester inline with the plug lead. With that, the internal light show (in neon tube) will give you an indication of the health of the ignition. Just watch the tube when the engine acts up.

Mine happens to be a Lisle 20610.

This presumes you can locate things out of harm's way, of course.

If the spark's okay, cease and desist cutting until you see that it's getting fuel. Or, melt a piston.

 

[Fish]

Screw that!!! Fix the saw before running it again!!! Start with the fuel system, and do it correctly!!!

 

[jughead500]

fuel filter sounds to be stopped up.my husky 55 done the same thing.

 

[HuskStihl]

Check the arrestor screen. Also check cold and hot compression. Good luck