Cutter Wheel Diagram needed

[CCrider]

I just picked up a older model Rayco Stump Grinder, model RG 1635A. It has 32 teeth on the cutter wheel and I am not sure they are in proper order. Where can i find a diagram showing proper teeth placement for this old grinder? And where would be the best place to order parts for this grinder if and when needed.

 

[lone wolf]

I just picked up a older model Rayco Stump Grinder, model RG 1635A. It has 32 teeth on the cutter wheel and I am not sure they are in proper order. Where can i find a diagram showing proper teeth placement for this old grinder? And where would be the best place to order parts for this grinder if and when needed.

Can you call rayco or are they out of business?

 

[Eq Broker]

Tooth Pattern

Are you using Rayco Superteeth? The pattern is pretty simple. Put 1 straight and 1 angled in one of the holes closest to the outside of the cutter wheel. You then go 180 degrees and do just the opposite. All of the other teeth should be rights and lefts and your good to go. If the wheel has only eighteen teeth, then rights and lefts will be ok for everything.

Hope this helps!

Dave

 

[CCrider]

Are you using Rayco Superteeth? The pattern is pretty simple. Put 1 straight and 1 angled in one of the holes closest to the outside of the cutter wheel. You then go 180 degrees and do just the opposite. All of the other teeth should be rights and lefts and your good to go. If the wheel has only eighteen teeth, then rights and lefts will be ok for everything.

Hope this helps!

Dave

Yes I ordered a new set of SUPER TEETH , they should be here any day now.

 

[CCrider]

Can you call rayco or are they out of business?

Great idea, and yes Rayco is very much still in business and they emailed me a diagram of the teeth locations for my particular machine.
Thanks for all your suggestions.

 

[Clay Bryan]

I just picked up a older model Rayco Stump Grinder, model RG 1635A. It has 32 teeth on the cutter wheel and I am not sure they are in proper order. Where can i find a diagram showing proper teeth placement for this old grinder? And where would be the best place to order parts for this grinder if and when needed.

Does it still have Rayco teeth, or has it been upgraded? I have an old 1631, bought new.