Sold dolmar makita husqvarna cylinders and some bars and fixer dolmar saw

[r black]

have a Makita/dolmar 6421 cylinder/piston, top cover 70$, good condition Husqvarna 365 special used cylinder ( has transfer will clean up) $35, also used Husqvarna large mount 20 and 24 inch bars, and stihl mount bars 18,20,28 . center oregan bar 18 odd ball see pics for mounting, make offer on all (would like to sell all bars to same buyer ) pic's are in order as listed ...pay-pal f/f or 3% + ship

 

[chipper1]

It's about time you cleaned that place up a bit Rod .
Great seller here guys.
GLWS buddy.

 

[r black]

thanks Brett , also adding this (low or no spark ) fixer clean sachs/dolmar 120 20 inch bar good compression chain brake.. good ....sold as is $150 plus ride same f/f pay-pal ....+ship ...I believe this is a coil/module issue think the 120 series has an in the flywheel coil assembly ...have NOT check out the issue with this saw ...

 

[r black]

pic's of the cover that go with the 6421 Makita/dolmar cylinder and piston all parts are oem stock ....after looking the Oregon bar on the dolmar 120 is 24 inch by the way the coil/module are the same as the ones used on these chop saws and chainsaws :
The 120 shares the Same SEM ignition as the 123/133/143 and 309/343 chop saws.
Makita dpc 7000/9500
Wacker bts 11/11/13
Stihl 056
Husky 380/480/2100/298/2101
And some 041 stihl

 

[r black]

the Husqvarna cylinder has sold and will ship out today .............update on the saw the dolmar does have spark.... may be just a fuel line and or carburetor issue

 

[r black]

any need for trimmer parts and or power head ? maruyama m23s runs.... does need carb kit..... power head only these seem to be good trimmers ...$55 plus the ride ??? .......note no fuel cap included ..........

 

[r black]

adding stihl ms 260 air filter cover (has crack ) and muffler (no cover) $10 Husqvarna 346xp ( and other saws) clutch cover $20 all oem used parts

 

[cuinrearview]

The 365 cylinder was my first transaction with Rod, and he is all business with great communication.

 

[r black]

pre-new year... ttt bump....no interest in a clean dolmar/sachs 120 ????...looks like I will be fixing it ...

 

[r black]

update on the dolmar had it running yesterday starts idles and oil's per design .....however is a coil/module issue as will not restart after several attempts/times and is a intermittent no spark... issue ...saw is clean inside and out

 

[mgr]

Big chance that the dolly has a bosh coil.

 

[r black]

Big chance that the dolly has a bosh coil.

very possible, may have a bosch... have not had the flywheel off yet it will start by (wiggling ) the coil wire and will start and run several times before going back to no (spark mode) I will be digging into it further at some point ...its definitely worth fixing ... now after removing all the covers and adjusting I am at...around 35 starts with no failures ...and counting

 

[r black]

after 50ish starts with no issue listing saw as running in the chainsaw adds

 

[r black]

sachs saw and the Husqvarna cylinder have sold ...rest available.... 28 inch stihl 3/8x50 bar 45$ ...3003 mount