F-350 Front End Suspension

[Slvrmple72]

Hey all! Gotta redo the front end cuz she's rattling plenty so I am looking for parts with grease fittings for replacements. Any suggestions? Gotta do the tie rods and ball joints. Had to replace the right front knuckle last year (destroyed the bearing race!) My truck is an 01 crew cab w/ 7.3 diesel and long bed. Thanks!

 

[brownie525]

Moog makes excellent suspension parts, thats what I would go with.

 

[autobaun70]

should have what you need at any Napa that handles Fleet/commercial vehicles. Other locations can easily get the parts, but the chances of them knowing what you are talking about is an entirely different issue.

 

[JCONN]

I would deffinetly go with moog I have a 97 f350 and had to replace some front end parts in a snow storm (I plow) they only had the cheap parts in stock. Needless to say I had to replace them again in about a year that crap just dont last.

 

[hermit]

I just did a 06 F350. Moog is what I used, Be sure to check clearance of the grease fitting on upper ball joint and axle joint may have to grind it off some.

 

[Frank Boyer]

Moog parts are the way to go. If you are doing the ball joints on a 4wd the u-joint will wipe out the zerk fitting on the upper ball joint. If your replacing the front bearing assembly make sure to get the o rings and new studs for both sides. OEM are cheaper than many vandors.

 

[Rookie1]

Moog makes excellent suspension parts, thats what I would go with.

:agree2: Moog is all I use at work and we have 3/4 ton ford trucks.

 

[Slvrmple72]

Thanks fellas! Moog it is!