- Joined
- Jul 20, 2014
- Messages
- 1,882
- Reaction score
- 2,527
I posted this in the "hot saw" forum as well but figured I'd try here. I have never done any porting beyond just cleaning up what was already there and some lower transfer work. That said, I've finally collected what i need to give i a go. I picked up a Frankenstein Husqvarna, it has 272 cases with a open port 61 Rancher topend. I'm Looking for advice on which way to go for my first time. Should I just port the 48mm cylinder or buy a cheap 50 or 52mm topend to grind on for my first attempt in case i screw it up? My knee jerk reaction is to do a 50mm topend so it fits under the 61 top cover. I just am not excited about the open port cylinder.
I already have a degree wheel, piston stop, and a grinder setup plus I've studied on this for literally years so I feel like I'm as prepared as I can be. lol
I already have a degree wheel, piston stop, and a grinder setup plus I've studied on this for literally years so I feel like I'm as prepared as I can be. lol