SOLD
This is a very clean 026 Pro. Although it is a Pro model, it no longer has a decompression valve, nor the means for one in the cylinder. I replaced the P&C with good used ones from a non-Pro model and installed new rings. It does have the adjustable oiler. The tank has been replaced with a clean, tooless capped MS 260 tank. It has a new, fully adjustable, compensated carb with the more desirable larger air filter. The muffler has been modded by opening the factory holes. The screen was left intact. I'm including a new 16" B&C, .325/.063. There is one very small chip in the filter cover plastic. Everything on the saw works properly. It starts and runs great. I set the carb a hair on the rich side at 13,500 RPMs. I'm asking $300 + shipping.
This is a very clean 026 Pro. Although it is a Pro model, it no longer has a decompression valve, nor the means for one in the cylinder. I replaced the P&C with good used ones from a non-Pro model and installed new rings. It does have the adjustable oiler. The tank has been replaced with a clean, tooless capped MS 260 tank. It has a new, fully adjustable, compensated carb with the more desirable larger air filter. The muffler has been modded by opening the factory holes. The screen was left intact. I'm including a new 16" B&C, .325/.063. There is one very small chip in the filter cover plastic. Everything on the saw works properly. It starts and runs great. I set the carb a hair on the rich side at 13,500 RPMs. I'm asking $300 + shipping.
Last edited:
