Anyone have a diagram of a greenteeth set up on a carliton 4400-4? I just recently bought the 700 series from treestuff and some of the pocket wont go on because they are too close together. Do I skip some pockets from the original standard set up?
Green teeth set up on a carliton 4400-4???
- Thread starter NCTREE
- Start date
Help Support Arborist Forum:
obwon
ArboristSite Lurker
Greenteeth setup
This is how the 1100 series was setup on my 4400-4 before I went to the New River Revolution wheel
![a>[IMG]](https://proxy.imagearchive.com/b03/b0371e3903541ac61fd271e5be1328cc)
This is how the 1100 series was setup on my 4400-4 before I went to the New River Revolution wheel
Last edited:
2treeornot2tree
Dont cry, just do it
Why did you get the 700 series teeth setup. My little machine runs the 900 series.
Main thing is you want the wheel to be balanced. If you get a drill press and bench grinder you can sharpen your own teeth. I sharpen mine just about after ever grinding, and I only have to touch them up. I got three sets of teeth so I can rotate them to.
Main thing is you want the wheel to be balanced. If you get a drill press and bench grinder you can sharpen your own teeth. I sharpen mine just about after ever grinding, and I only have to touch them up. I got three sets of teeth so I can rotate them to.
howel07264
ArboristSite Operative
These are way to small for your machine. I run 1100 series deep dish greens on both my 4400-4 and 7015trx and they work fine. It does take less hp. to run the 700s but you will be wearing them out in 1/3 the time of the 1100s. The reason they recommend the 700s is they get to sell you 3 times the teeth. As for skipping pockets, I don't run inside teeth/pockets (pockets closest to shaft) on the 4400-4 and it cuts fine.
