Menu
Forums
New posts
Search forums
Terms and Rules
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Terms and Rules
Menu
Log in
Register
Install the app
Install
Forums
Equipment Forums
Chainsaw
How long can you keep the throttle wide open without load?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Arborist Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="anynameyouwish" data-source="post: 8096505" data-attributes="member: 178488"><p>Question for you all (couldn't find the answer online): How long can you keep the throttle at full when tuning the H jet? My tach (proline solo) takes a few seconds, sometimes 3-5, to register the RPM reading. Is it OK to run WOT without load for, say, 5 seconds? What I've been doing is full throttle for few seconds, note RPM reading, wait for a few minutes, adjust carb by an eighth turn, recheck RPM, etc. </p><p></p><p>(Thank you all for excellent advice on the other threads I've started recently!)</p></blockquote><p></p>
[QUOTE="anynameyouwish, post: 8096505, member: 178488"] Question for you all (couldn't find the answer online): How long can you keep the throttle at full when tuning the H jet? My tach (proline solo) takes a few seconds, sometimes 3-5, to register the RPM reading. Is it OK to run WOT without load for, say, 5 seconds? What I've been doing is full throttle for few seconds, note RPM reading, wait for a few minutes, adjust carb by an eighth turn, recheck RPM, etc. (Thank you all for excellent advice on the other threads I've started recently!) [/QUOTE]
Insert quotes…
Verification
Post reply
Top