Husky 350 choke diagram

[Smcgill]

My Husky 350's choke seams to not be working.
Some thing came off or broke.. and I'm lost..
Does some one have pics or a diagram to help me locate the problem ...
Thanks

 

[dsell]

 

[Smcgill]

How about were it mounts to the carb?

 

[dsell]

See the end of the blue lever? It just pushes into the carb choke lever.

 

[dsell]

This is the throttle side. When you pull the choke out, it turns on the ignition switch, chokes it, and set the high idle. Squeeze the throttle trigger once and it release the high idle.

 

[dsell]

Is your's broke? What is it doing wrong? It is probably the best system of it's time and easy to work on. The intake on that saw is another story.

 

[Smcgill]

When I try to start the saw the choke is open when I have the blue tab fully pulled out.
When I take the cover off the wing isn't connected to anything else. I can push it down and it clicks in.
I can start it then.
I hope I'm explaining ok..

 

[dsell]

Yes, either the blue tip popped out of the choke or it broke.

 

[Smcgill]

Yes, either the blue tip popped out of the choke or it broke.

Hmmm I'll look closely in that area..
Thanks

 

[huskihl]

Good advice. This might help. As mentioned, the end of the choke lever has slipped out of the linkage. They usually stay put but yours may need to be pried apart after it’s installed to keep it in place.

 

[Smcgill]

I knew someone here would know.
I'll report back ..
Thanks

 

[Smcgill]

Hmmm not so obverses ..
I'll have to check out u-tube on how to remove the carb on a Husky 350 ..
I'll get back to all

 

[Wood Doctor]

Hope this helps. Good Luck!

 

[huskihl]

There’s no need to remove it if your choke lever isn’t damaged. There’s enough room to shine down in there with a light and line it up and pry it in with a small screwdriver

 

[Smcgill]

How is the primer bulb removed..I think if I could remove that I could see it better..

 

[dsell]

How is the primer bulb removed..I think if I could remove that I could see it better..

Do you have a 450?

 

[Smcgill]

350

 

[dsell]

Can you post some pictures of the saw, primer, carburetor, and choke?

 

[Smcgill]

I will If I remember to when I get home ...

 

[dsell]

Why are you removing the carburetor?