husky 359 carb screws

[Lonewolf359]

How do you get the carb limiters off? I only have about 3/4 of a turn oneither the high or low speed screws.:bang:

 

[kf_tree]

How do you get the carb limiters off? I only have about 3/4 of a turn oneither the high or low speed screws.:bang:

i just take a small pair of diagonal cutting pliars and snip the stops off.

 

[SWE#Kipp]

I take a knife and just cut the "flags" off works fine i think ,,,,,

 

[Lonewolf359]

Doen't seem like there is a whole lotta room to snip the tabs off! Are the white and black ends removeable?

 

[kf_tree]

these are what i use and if there are any rough edge's i sneek in with a small file to clean it up.

 

[kf_tree]

lone wolf

yesterday i realized i gave you bad advice.........i used those pliers to remove the stops on 372's and a makita i have with the carb in place. but i went to cut them off of a 357 and i had to pull the carb off to get to the stops.