Husky 455 Rancher Piston and Cylinder

[Jovak1]

I Disassembled my 455 Rancher I picked up recently. I knew it needed a new seal and fuel line so I decided to check the piston and cylinder.
I think they are ok, but I am asking my fellow Chainsaw Brethren what their opinion is.
So, what so say you everyone?
I am thinking I should just clean the piston, install new seals, clean the carb, and reassemble.
I also included a pic of the carb adjustment screws. It does not appear these are able to be customized - remove caps

I also attached a pic of the piston ring. It looked good.

Thanks

.

 

[brandonstc6]

Others will chime in soon, but if it were mine, as long as the cylinder walls were smooth. I'd buy a new caber ring for it and run it.


Sent from my iPhone using Tapatalk

 

[Mattyo]

New ring....put it back together.

Check my youtube channel for a bolt for bolt vid on 455s.

 

[Jovak1]

New ring....put it back together.

Check my youtube channel for a bolt for bolt vid on 455s.

Thanks, I have checked out your YouTube channel. BTW do you know if the 455 carbs can have the caps removed?

 

[Mattyo]

I have not done it...but I think if you press the detent in....then unscrew the screws you should be able to remove the limiters.