Husky sg 13

[stump stomper]

I to am in the stump biz its a bit quite this year so decided to service the stumper my self new teeth pockets bearings do you think i can get the old bearings off 2 days still no good had to leave it in to engineering company any body have any tips for the next time they have to be replaced.



http://www.pickapro.ie/tree-stump-shrub-removal/Stump+Stompers/

 

[stumpgo]

Using an angle grinder works pretty well.

First destroy all the outer bits of the bearing using a cutting disc. Leaving just the offending inner sleeve on the shaft.

Change to a grinding disc and carefully thin the sleeve at 2 opposite points until nearly through.

Whack the side of the sleeve with a hammer and chisel and it should move or break easily.

If not, just grind a little more and repeat.

 

[stump stomper]

Thank stumpgo
the last time they had to be replaced i just left it in to a guy who dose lawnmowers etc.. thanks for the tip when i go near that type of thing it all goes peat tong ie lose bits snap something ring nuts you know the kind of thing