Hello.
I'm fighting with a Husqvarna 236 / Poulan chainsaw crap.
the carburetor is unadjustable. always stalls when accelerating. very difficult to start.
Leak-down ok, new membrane, ignition ok. the modification to seal the piston with epoxy did not change anything.
test with a copy of Chinese caburator. Starts great, accelerates much better. but the engine speed is not stable.
I plan to make an intake pipe to plug the stratified scavenge hole and fit a Walbro carburetor.
Has anyone tried the operation yet?
I'm fighting with a Husqvarna 236 / Poulan chainsaw crap.
the carburetor is unadjustable. always stalls when accelerating. very difficult to start.
Leak-down ok, new membrane, ignition ok. the modification to seal the piston with epoxy did not change anything.
test with a copy of Chinese caburator. Starts great, accelerates much better. but the engine speed is not stable.
I plan to make an intake pipe to plug the stratified scavenge hole and fit a Walbro carburetor.
Has anyone tried the operation yet?
