Steven Trexler
ArboristSite Guru
First off is a Husqvarna 268xp. Saw seems to run fine but piston is showing some scratches on exhaust side so probably wouldn't hurt to pull cylinder and check it out compression is around 140psi and for some reason my tester would not seal around the plug hole so that's 140psi with some leaking out the plug hole as you can tell in the picture by the gas mixture coming out around the hole. I would like to get $175 plus shipping PHO
Second saw is an early 12mm Stihl 044. Saw runs and oils. Compression is just over 160psi. I have not cut with this saw so may need some tuning. I would like to get $350 shipped PHO, not much wiggle room on this one. I do have an oem spike I will put on the saw.
Second saw is an early 12mm Stihl 044. Saw runs and oils. Compression is just over 160psi. I have not cut with this saw so may need some tuning. I would like to get $350 shipped PHO, not much wiggle room on this one. I do have an oem spike I will put on the saw.
Attachments
-
2014-12-24_16-09-14_859.jpg68.2 KB
-
2014-12-24_15-48-22_554.jpg46.3 KB
-
2014-12-24_15-43-12_535.jpg63.7 KB
-
2014-12-24_15-43-04_991.jpg52.1 KB
-
2014-12-24_15-42-59_740.jpg65.6 KB
-
2014-12-24_15-42-49_867.jpg60.2 KB
-
2014-12-24_15-40-52_947.jpg60.3 KB
-
2014-12-24_15-40-37_823.jpg53.4 KB
-
2014-12-24_15-40-45_826.jpg49.1 KB