I WILL BE LISTING SEVERAL OF THESE SAWS. THESE SAW ARE PROJECT SAWS AS ALL OF THEM WILL NEED SOME WORK. I WILL DO MY BEST TO DESCRIBE WHAT I SEEN WHEN GOING OVER THEM. SAWS WHERE THROW TO THE SIDE WHEN THEY STOPPED RUNNING OR HAD PROBLEMS.
SAW#1 is a 288xp with low compression but it will still start and run. Cylinder is a Mahle and there is no scoring on the cylinder when looking threw the exhaust port. I'm sure it will need a new piston and ring. Saw will also need the following, clutch cover, idle screw, air shroud, kill switch, and a repair on the top cover bolt holes. Plastics are faded and there is a patch on the bottom of the tank. Bottom end of the saw sounded good when running, no noise from the bearings. Plastics are faded and top cover does have a few small cracks.
150.00 +SHIPPING
SAW#1 is a 288xp with low compression but it will still start and run. Cylinder is a Mahle and there is no scoring on the cylinder when looking threw the exhaust port. I'm sure it will need a new piston and ring. Saw will also need the following, clutch cover, idle screw, air shroud, kill switch, and a repair on the top cover bolt holes. Plastics are faded and there is a patch on the bottom of the tank. Bottom end of the saw sounded good when running, no noise from the bearings. Plastics are faded and top cover does have a few small cracks.
150.00 +SHIPPING
