346XP (OE).
Recent work done to it:
-4 1/2 point valve job
-Tire rotation (though it is still riding on one donut, so take her slow)
-Fuzzless dice were professionally refuzzed and air freshener replaced
-Broken antenna replaced with a barbecue skewer, with a few pieces of shish kebab still intact
Wait... I think I'm in the wrong room...
Piston was junk when I got it, so I put a new Meteror piston kit in it, along with a good used, clean OEM cylinder, and upgraded the intake to the metal clamp from the loose plastic clamp that smoked it. While doing so, I deleted the base gasket. Saw runs as it should. Also, not shown in photos is the second bar nut.
$350 + the ride.
Bryan
Recent work done to it:
-4 1/2 point valve job
-Tire rotation (though it is still riding on one donut, so take her slow)
-Fuzzless dice were professionally refuzzed and air freshener replaced
-Broken antenna replaced with a barbecue skewer, with a few pieces of shish kebab still intact
Wait... I think I'm in the wrong room...
Piston was junk when I got it, so I put a new Meteror piston kit in it, along with a good used, clean OEM cylinder, and upgraded the intake to the metal clamp from the loose plastic clamp that smoked it. While doing so, I deleted the base gasket. Saw runs as it should. Also, not shown in photos is the second bar nut.
$350 + the ride.
Bryan