brandonstc6
Addicted to ArboristSite
Husqvarna 372xp. I rebuilt this saw.
New oem:
Intake boot
Seals
Gaskets
Air filter
Full wrap handle
Spikes
Decomp valve
Non oem parts:
Nachi C3 bearings (made in Japan)
Meteor piston
Aftermarket muffler
Aftermarket carburetor (oem carburetor is included.)
Aftermarket clutch cover
Saw has a little burnt place in the top cover from a poorly modded muffler. Saw start right up and runs. Once you put it in wood it speeds up on it’s on in the cut, otherwise it runs pretty good. I’m not sure what’s going on. Oem carburetor worked at first but then saw wouldn’t run until I put the aftermarket carburetor on it. Saw has not been run enough for rings to seat. Saw will need broken in and the issue of engine speed picking up fixed. Saw has the tensioner in the case instead of the clutch cover. Cylinder had no scoring at all and the plating looked great. I’ve spent a lot of time on this saw and I’m ready to move on to something else. All machining marks still on piston. I’ve run maybe 1/2 a tank through it. $275 plus shipping.
Add 3% if paying PayPal goods and services.
Sent from my iPhone using Tapatalk
New oem:
Intake boot
Seals
Gaskets
Air filter
Full wrap handle
Spikes
Decomp valve
Non oem parts:
Nachi C3 bearings (made in Japan)
Meteor piston
Aftermarket muffler
Aftermarket carburetor (oem carburetor is included.)
Aftermarket clutch cover
Saw has a little burnt place in the top cover from a poorly modded muffler. Saw start right up and runs. Once you put it in wood it speeds up on it’s on in the cut, otherwise it runs pretty good. I’m not sure what’s going on. Oem carburetor worked at first but then saw wouldn’t run until I put the aftermarket carburetor on it. Saw has not been run enough for rings to seat. Saw will need broken in and the issue of engine speed picking up fixed. Saw has the tensioner in the case instead of the clutch cover. Cylinder had no scoring at all and the plating looked great. I’ve spent a lot of time on this saw and I’m ready to move on to something else. All machining marks still on piston. I’ve run maybe 1/2 a tank through it. $275 plus shipping.
Add 3% if paying PayPal goods and services.
Sent from my iPhone using Tapatalk
