Hydraulic slab bing mill

[Tnslabber]

I would like to run a 72 or84" bar attach to a hydraulic motor or add a pulley to get the right speed. I'd like to run it with my 90 hp skid steer 40 gpm at 3000 any help would be much appreciated. Thanks

 

[mdavlee]

Look at buck saws for the motor and right gearing.

 

[kimosawboy]

I have wound up at this site more than once but I could not recall the name, after a bit of looking I found it in another thread at this site...Anyways there might be something there that can help..
http://www.danzcoinc.com/

G Vavra

 

[Tnslabber]

Look at buck saws for the motor and right gearing.

thanks i'll check it out

I have wound up at this site more than once but I could not recall the name, after a bit of looking I found it in another thread at this site...Anyways there might be something there that can help..
http://www.danzcoinc.com/

G Vavra

thanks for the info I spoke to Ed at dansco and he said his gear wasn't suited for milling other than a good selection of sprockets. Still looking for the right motor Thanks again