I need a little help please

[94TahoeLT]

I've been lurking around for awhile, and decided to finally post.
I'm having trouble finding some saw parts.
I need a rear handle & trigger for a 015 AV. (it fell off the tail-gate, I'm thinking I should replace the saw with a new Echo)

A new muffler for a 028, (the metal rusted out around the mounting holes)

also I need a ring and crank seals for my poulon 2150, At least I think.
The problem is I can cut small stuff but when I bury the 14" bar, It will only run for a few minutes then dies. after a 5 minute wait it runs fine again.
So I'm thinking it's a low compression problem. it's a 1995 model, I have replaced the bar at least 3 times and At least a dozen chains over the years.

Thanks Scott

 

[bugfart]

Sounds like it's running too lean, richen it up

 

[Lakeside53]

I emailed you with the source to get all this stuff, except the poulan. Definitely richen up the H screw...

 

[94TahoeLT]

Leaning out the poulon helped, But I found the fuel line broke in the gas tank.
I'll have to order one of those also.