Freakingstang
Doctor Freakinstein
This is a well used 2002 Jonsered 2186. Uses same parts as a husky 385. This was an ex logging saw, so it has seen some use. I bought it to be my big saw, but after selling the 066, and then finding another, I just need to get rid of a couple. It is no beauty contest winner, but it is a good runner. Would make someone a good mill saw, not looking to spend much cash. Here are the known problems:
1)There is a chip in the case below the choke lever. Doesn't affect performance, but it is noticable.
2)There is a small chip in the oil cap lip. I haven't noticed it leaking while running the saw, but it will dribble oil it it sits with a full tank.
3) One of the cylinder bolts isn't the same size as as the rest. I'm guessing it was stripped and they put the next size up bolt in it.
4) It is missing the outside dawg (clutch cover side).
I put a new handle bar and a new piston/rings in it. It carries about 145 lbs compression with newly installed rings. I have ran about 3 tanks thru it, since the new piston and rings. Runs good, just looks ugly. I would like to have 300 shipped out of it. I have a couple bars that could go with it, 18". 20" and 24".
Note, The muffler in the pics will not be included. It will have a modded muffler with a hole in the muffler bracket and spark screen in place. I will post pics of that muffler if anyone is interested in the saw.
-Steve
1)There is a chip in the case below the choke lever. Doesn't affect performance, but it is noticable.
2)There is a small chip in the oil cap lip. I haven't noticed it leaking while running the saw, but it will dribble oil it it sits with a full tank.
3) One of the cylinder bolts isn't the same size as as the rest. I'm guessing it was stripped and they put the next size up bolt in it.
4) It is missing the outside dawg (clutch cover side).
I put a new handle bar and a new piston/rings in it. It carries about 145 lbs compression with newly installed rings. I have ran about 3 tanks thru it, since the new piston and rings. Runs good, just looks ugly. I would like to have 300 shipped out of it. I have a couple bars that could go with it, 18". 20" and 24".
Note, The muffler in the pics will not be included. It will have a modded muffler with a hole in the muffler bracket and spark screen in place. I will post pics of that muffler if anyone is interested in the saw.
-Steve
