msjanket
ArboristSite Operative
I wanted to increase the flow of oil on my 49. Curious, I removed what appeared to be part of the mechanism on the bottom of the saw. After removal of this part, I noticed I could not re-insert this into the mechanism.
Is this remedied by removal of two allen screws on the lower front of the machine, pulling the part out a bit, then inserting the bottom mechanism and tightening it down, the re-screwing the two Allen screws on the front lower of the machine? I don't have a schematic on my "new" unit.
thanks, all
Mike
Is this remedied by removal of two allen screws on the lower front of the machine, pulling the part out a bit, then inserting the bottom mechanism and tightening it down, the re-screwing the two Allen screws on the front lower of the machine? I don't have a schematic on my "new" unit.
thanks, all
Mike
