Hey guys, I'm looking to buy a heated handle saw or the parts needed to make the heating system. Stihl, Jonsered, Dolmar or Husky saws preferred. 50cc or bigger, ideally looking for a 60/70cc saw.
-
If you have bought, sold or gained information from our Classifieds, please donate to Arborsist Site and give back.
You can become a Supporting Member which comes with a decal or just click here to donate.
Want to Buy Looking for heated handle saw or parts
- Thread starter epicklein22
- Start date
Help Support Arborist Forum:
TBrown
more saws than I need
I think I have the stuff for a ms460
Stator, flywheel, carb plate, rear handle heater, switch, and half wrap. (Is bent and needs tweeking)
Stator, flywheel, carb plate, rear handle heater, switch, and half wrap. (Is bent and needs tweeking)
beowulf67
ArboristSite Operative
Hi Andrew.....still looking for a heated saw? Contact me at609 731 7437 or pm me. I have a nice ms460 arctic...thnx Pete
I have a 266xpg, new bearings & seals, fresh meteor piston. I bought it here as a project and fixed it, squished at .020. The heater works. 185 PSI at a mile high. If you are interested pm me. The only reason I'd sell it is my saw racks are full. 262 x 5, 266, 268, 272 x2, 288, 346, 357, 372, 395 x2, 576, 2100, 10 mm 044, ms440/o44's, 026 ported, 261cm.
eudaimonea
Refurb Advocate
Good lord thats a lot of saws! How did the 026 respond to porting?
ChoppyChoppy
Tree Freak
I have a 460 or 660 parts saw (I forget which) with handle heater
eudaimonea
Refurb Advocate
Have generator handle and switch but no flywheel for 266 268 etc. Want to sell or swap
It's a fun saw, it was the second 0h26 that a builder in NC did and it's a ripper. I took it to a tree trimmers job site and let him run it. He wants to do his 026 now. The biggest problem is getting enough air to flow through the intake system.
That builder did a third for another guy and it was even more radical. I traded an extra foley 308 chain grinder for the 026 work...
On the number of saws, after the flood we had in September 2010 I found that I didn't have enough big saws.... Then I started buying mostly thrashed saws and repaired them. I'm going down to pick up a MS360 that has an oil leak today from a Stihl dealer.
Similar threads
Withdrawn
Stihl MS 361 Parts Saw
