Sold mastermind 285/2100

[Tnshaker]

Husqvarna 285 with 2100 top end ported by Mastermind. This saw is a monster! Ask randy. Some pics are listed much deeper in one of his threads. I can post pics later. This saw is very clean for its age. He also installed the big starter handle to help crank 99cc of ported muscle. I love this saw but after buying 3 saws in 6 days something has to go. I had too many before the last 6 days..lol. I am asking $525 plus shipping for pho. I can supply a nice 28" husqvarna bar and chain for an extra $70.

 

[bryanr2]

I can definately relate to your predicament. Good luck on the sale.

 

[mdavlee]

I seen it in person on Randy's bench. It is a nice specimen.

 

[bryanr2]

would it make a good milling saw Mike?

 

[mdavlee]

would it make a good milling saw Mike?

Would be a pretty good one for that size. It has a little more torque than a 394/5. I have an 088 on the way now to use for that.

 

[fin460]

cool saw

 

[Tnshaker]

May consider some trade offers on this saw.

 

[William Balaska]

I'd like to see pictures, semi interested.

 

[Tnshaker]

Will try to post pics a little later...this is a nice one.

 

[Tractorsaw1]

I couldn't find a thread on the build, pictures, or anything. Link or name of the thread would be nice too. thanks

 

[Tnshaker]

Posted a couple pics...will post a few more later.

 

[Tnshaker]

Randy bridge ported this saw.....99cc of masterminded bridge ported power. Since this saw is a 285 is is an auto oiler and makes it a 298xp essentially. No worries about the o rings on the manual oiler with a regular 2100.

 

[fastLeo151]

What's bridge port? You got to break it down for dummies like me...

 

[Jacob J.]

What's bridge port? You got to break it down for dummies like me...

I think bridge porting means that Randy cut fingers over the transfer bridges. This is a 394 jug that was ported by a guy local to me, it represents bridge porting. Randy did cut the squish band in this for me so's I can run a 2101 piston after I clean up the ports.

 

[Tnshaker]

Randy or mike can explain much better than I. Similar but not the same as finger porting. I can tell u that this type of porting really utilizes torque of a saw.

 

[Tnshaker]

Thanks Jacob! Or Jacob can explain..lol. special thanks to Jacob as he was the one who acquired the piston and cylinder for this saw.

 

[fastLeo151]

Its a open and closed port saw then? I'd just call that a finger port but I understand now.

 

[Jacob J.]

Its a open and closed port saw then? I'd just call that a finger port but I understand now.

What it does is widen the fuel curve at high RPM.

 

[Tnshaker]

I will do $ 500 plus shipping on this saw or consider trades plus cash or may add cash depending on trade.

 

[fastLeo151]

That would look sweet on my saw shelf