morbark model 13

[sleepingintrees]

I am in the process of changing bearings on the lower infeed roller one was shot so getting the housing off was not to hard -I want to replace both bearings the other side is tough help would be appreciated !!

Should I just cut the coupler and bearing i have already broke a bolt on my puller and put heat on bearing !!!!!!

pic…...

 

[Eq Broker]

You can either remove them with a cutting torch or ziz wheel. Be careful not to get into the shaft. Upon removing the bearings, inspect the shaft and make sure where the bearing seats that it hasn't damaged the shaft. Take emory tape and clean up the shaft prior to installing the bearings. If the shaft has a step in it where the bearing seats, you'll have to purchase a lower feed wheel. Let's hope this didn't happen.

Hope this helps!

Dave
Global Equipment Exporters
770-420-6400

 

[TRISTATEFORESTRYEQUIPMENT]

you need more heat, and a bigger puller, it will come off.

joe
TriState Forestry Equipment

 

[CalTreeEquip]

Just cut them off.