Need help from one of you RG50 guys

[Plyscamp]

I am working on a project converting a Vermeer SC252 to a 3 cylinder 44 HP diesel. My plan is to drive the cutting wheel hydraulicly. What I need is the manufacturers name and part # on the hydraulic pump and motor that drive the cutting wheel on a RG50. Any help would most certainly be appriciated.

 

[Plyscamp]

OK lets try this again. Is there any info on the pump such as GPM (Gallons Per Minute) and PSI. Thanks in advance.

 

[a_lopa]

No doubt the "rayco part #" will be there own part # not the manufacturer of the motor as it is so often.

good luck