Olympyk Sprocket

[django]

I recently purchased an OLy 264F and need the spur sprocket. I would like to buy from an ArboristSite sponser. Who would that be?
Thanks,

 

[django]

Anybody? Throw me a frikin, bone people.

 

[kam]

OLy 264F

Mack, a member of AS is or was a dealer for Olympyk /Oleo-Mac.He doesn't
post much now, so he may not have seen your post.
Try a PM or this is his homepage, though he does not list Olympyk /Oleo-Mac

http://www.mackenziepower.com/index.php

 

[Chris J.]

Okay, this' my 3rd try, d@mn AS software problems.

Alrighty, a small bone. Django, in the used equipment forum I have listed quite a few sprockets. Most are hub sprockets, & I didn't find a reference for Olympic saws. Check it out, you might find one that'll work.

 

[pallis]

You might go to Tilton and find a dealer. http://tiltonequipment.com Oregon still makes some sprockets for the older Olympyks or they still have some in stock. Go to the Oregon site and look up your saw. My 355, for instance, uses 13916X in a rim setup. Also, I bet Bailey's could find what you need. I didn't answer because I figured someone would be along and fix you up with more than suggestions.

Pat

 

[django]

Thanks for the help. I have looked at Oregon's site. Nothing. I actually have a dealer near me that can order me a sprocket, however, it'll be over $30. That is a ridiculous price for a sprocket, and I am cheap to boot. I only gave $50 for the saw in the first place. It's actually a very nice saw, great compression and the bore is flawless. I rebuilt the carb and it runs great. Just trying to keep the cost down as much as possible. Part of the pride of ownership of the saws I have is how good they run and how little money I have in them. I'll exhaust all other possibilities before I cough up $30 for a sprocket. I am antsy to cut some wood with it but the sprocket is so bad I won't even try it out, ruin a good chain.

 

[Chris J.]

Ray Benson posted a very useful link in my sprocket thread, and it is still there. I'm guessing that you didn't bother looking? Here you go, and you're welcome, in advance.

http://herrmfg.com/sprockets.htm

 

[woodchop]

Total Part # 044-A7 $15.50

 

[django]

Yup, I "bothered" to look. Good link. Can't get ahold of a human being there yet. Thanks, after the fact.

 

[django]

Total Part # 044-A7 $15.50

Woodchop, thanks, but I think that part is for the "deluxe" model. The deluxe has a threaded on clutch and the standard ( like mine) is a press on clutch.

 

[woodchop]

Oops.
264 STD
Total part #: 7 teeth sprocket TN045A7, 8 teeth sprocket TN045L8

264 Deluxe is TO44A7