Pine Milled Today

[burningwood]

We milled just under 156 total board feet today. I did get a late start but things went well with a break for lunch around two. These slabs are 1.25 thick, just under twelve feet with the widest board 19.25 and the smallest 15.25.

I did get the aux. oiler and the mini mill hooked up but never used the mini mill. The last thing we did was (smokin speak) was pop the top off from the pine we hope to mill tomorrow, attached are some pictures.

bw

View attachment 193116View attachment 193117View attachment 193118View attachment 193119View attachment 193120

 

[willbarryrec]

Well Done!

Looks good.

And it looks like your getting a real smooth cut.:msp_smile:

I 'm envious of your rail setup...What is that from? I know I've seen it before.
I just use 2x4s and I find myself wishing for something all one piece and a bit more rigid.

 

[burningwood]

Rail Setup

Looks good.

And it looks like your getting a real smooth cut.:msp_smile:

I 'm envious of your rail setup...What is that from? I know I've seen it before.
I just use 2x4s and I find myself wishing for something all one piece and a bit more rigid.

The ez rails are sold by Baileys and Granberg, they come in nine foot sections and five foot sections.

I'm using a Carlton chain with the 36 inch bar.

bw

 

[willbarryrec]

The ez rails are sold by Baileys and Granberg, they come in nine foot sections and five foot sections.

Nice,I'll check those out.